How to avoid common errors while picking drones for the Armed Forces - specialist advice (photo)

This can be checked if you take the rays diagonally and disrupt. The smallest backlash is to reach the screws. If the nut should fix the beam screw, scroll - it is necessary to fill the fixer. When using the electric screw, the screw should be pulled by a hand screwdriver to the stop. The angle of tilt of the camera should be adjustable with your hands, but be tension. The camera should not hang, but should not be fixed rigidly.

The antenna mount should not include the nuts shown in the photo - it is scroll with them. The mounting of the pigtail should be strong and not hang. "The antenna should be very tight. If it falls off in flight, the drone will fall. " "There are pigtails that can be twisted. Here are well suited from the camera. We take them and twist them to the stop. There are also options with holes without thread - we are fastened to thin ties, but we also tighten them.

" The power supply should be fixed closer to the end of the frame. Otherwise, it can get into the propeller, which will lead to drone loss. The receiver should be fixed on the frame. The wires should not stick out and hang out. It is better to twist the wires together during assembly. But you should not clamp wires from VTX and RX together, it can lead to problems. It is better to solder RX on uart6.

If you solder on UART2, the wires will go through the entire FC and it will be more difficult to attach battery -strewn. "The wires of the motors should be invested without arches, one on one. I saw the wire interrupted by the fact that he was hanging. Although it would seem like that. Well, with arc FC and knock down a gyroscope. " Stack (FC+Esc) bolts should be taken from the frame. Those that come with the stack are long. They rest on the frame, do not allow to attach the strength.

An effort to record "leads to a lot of problems and the time spent. " The soldering should be checked carefully. The drones fly under load, fall, so the connection of the contacts must be reliable. Completeness from the supplier can be broken. Some elements may not be enough, some will be superfluous. It is necessary to store everything carefully, including with wires - you will need. Only proven propellars are required, HQPROP 7X4X3 are recommended. "Another video.

It is better to buy a corner pigtail if the VTX connector comes out somewhere inconvenient. If it breaks, there will be problems with the video and the drone will not fly. " "Some VTX, when installing iron bolts to the frame, start giving horrible noises on video. This is because the Carbon Rama is a conductor and it is attached to the VTX body, which is often" Earth Draw VTX screeds. " It is extremely important that the drone binds in a standard way (3 times supply power, or through a button).

It is not necessary to put bind-phrases so that the drone is tested. It is also advisable to leave ordinary music on ESC. If the drone has a non -standard bond or other deviations from the standard settings, you should leave it with a permanent marker so that it should not be guessed at the landfill. If the note is on the sticker, it can fly in flight. We remind that a month ago, more than 10,000 people were ready to support the People's FPV initiative and collect their own drones at home.